Renewable Design for Modular Belts P=1″ Belt Har 1400 flat type to Netherlands Factories

Har 1400 flat type          

Thickness: 12.8mm

Our company has been qualified with ISO 9001:2000 quality system. The product strictly complies with the standard and procedures of ISO 9001, which ensures good product quality. So our products have some advantages, for example:

1. Easy installation and maintenance
2. High mechanical strength and wear resistance
3. Low friction coefficient
4. Excellent product handling
5. High performance

We are a leading manufacturer of modular belts with professional team; we can provide you with excellent quality items. This kind of modular belt can be used in the following industries:
Beverage industry such as acceleration, depletive and accumulation.
Food industry such as cool off lines and pack lines.
Meat industry such as tray pack line and metal detectors.
Our products are mainly used in bakery industry including dough transport, cooling lines, internal transport, metal detectors and packaging lines
Seafood applications including tray packing lines
spiral applications as proofing and freezing of croissants, cooling and resting
Bakery applications including raw dough handling, cooling lines and packing lines
Fruit vegetable applications including elevators, inspection tables and packaging lines.

https://www.how-to-repair.com/help/repair-guides/washing-machines/heating-systems-washing-machines/
washing machine not heating, We are going to show you how to fit the new element and thermostat to this Bosch, Neff or Siemens washing machine this process should be pretty similar to your make and model of front loading machine.
Safety first disconnect your washing machine from the power supply and it’s a good idea to turn the washing machine water supply of,
1. Remove two screws from back of the top panel. These are normally torx head screws and you can get a full set of these torques bits in our tool section.
2. Take out the soap dispenser draw by pressing the button on top.
3. Remove front panel after removing screws, do keep these screws separate because they’re stainless steel.
4. Remove the kick strip and pump flap normally one screw.
5. Remove this retaining clip which is holding the door seal against the machine. There are lots of different ways that these retaining clips work, see video.
6. Remove screws that are now holding the front panel of machine on.
7. Remove door interlock, two screws.
8. Peel back door seal after taking the retaining clip of. See video
9. The element is situated at the bottom of the drum. Take photo of the wiring before disconnecting it.
10. Just uncouple the wires attached to the thermostat. Usually block connector.
11. Undo this nut which is attached to the retaining clip, with a spanner or a socket. Don’t undo it all the way because you have to tap the nut in, to release the pressure on the seal, then with a flat bade screw driver prise the washing machine heater element away from the outer tube. Be careful with this
12. The thermostat is a push fit into the element
13. If you need to check if the element has blown you will need to use a multi-meter to test it.
14. Replace which part is need and reverse this procedure

https://www.qlzgconveyor.com/
Our company has rich experience in design ,select and install various types of conveyor equipment .The factory covers an area of 30000 square meters ,about 200 staff ,including sales, production, engineering and technical department .The register trademark ’QLZG’ , we obtain the ISO9001 certification issued by the state and the production license certificate.